Hp 6000 User Manual download pdf (Page 24)

Chapter 2 - Software Overview Measurement Settings

Measurement Settings

Instrument Selection and Settings

You can now choose from multiple combinations of instruments such as a Signal Generator and Power Meter or Signal

Generator and Spectrum Analyzer.

Available Modes of Operation

1. VNA ONLY

2. Signal Generator and Power Meter

3. Signal Generator and Spectrum Analyzer

4. Signal Generator and Multimeter

5. Special Recieve Only Mode.

6. Emulation Mode. (Simulated Dipole Measurement)

(NOTE: Any instrument that you want to select must be

configured in the VEE I/O Configuration program prior to

selection)

Source Instrument Settings

Receive Instrument -Power Meter Settings

NOTE: These settings also apply for the RECEIVE

ONLY instrument.

Start / Stop Frequency- Enter the frequency in GHz

Decimals are ok , example: 450Mhz = .45

Number of points- Similar to a VNA configuration

you may choose the number of frequency points for

the sweep, click the “Freq Increments” window to

display the calculated Frequency Step.

Output Power- Sets the output power of the Signal

Generator. format is dBm.

Trigger Mode- Changes the way the power meter

reads the sensor, this setting is only applied to

certain meters.

Trigger Delay- This sets the delay / Settling time

between when the Signal generator is called and the

power meter is queried for a reading. format is in

seconds. Example: 1/10 second = .10

Sweep Delay- this sets the number of seconds the

signal generator will wait before initiating the sweep.

this allows larger antennas a chance to completely

stop moving.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 54 55

No comments

Hp 6000 User Manual Page 24