HP ProOne 400 G4 20-inch Non-Touch All-in-One Business PC User Manual download pdf (Page 33)

Replacing drives

Replacing a hard drive

The 2.5 inch primary hard drive is installed on the right side of the computer. To locate the hard drive on the

system board, see Locating internal components on page 23.

Removing a hard drive

1. Remove the screw securing the hard drive to the computer.

2. Slide the hard drive away the edge of the computer and lift the hard drive out of the computer.

3. Disconnect the power and data cables from the hard drive. There is a tab you can pull to disconnect

these cables.

4. Remove the four mounting screws from the 2.5 inch hard drive cage (1). Be sure to keep the screws to

use to install a replacement drive. Remove the hard drive (2).

For instructions on installing a hard drive, see Installing a 2.5 inch hard disk drive on page 27.

Installing a 2.5 inch hard disk drive

1. Insert the hard drive into the drive cage (1) and fasten four mounting screws onto the new 2.5 inch hard

drive (2).

2. Position the hard drive above the drive cage with the connectors facing the power and data cables.

Replacing drives 27

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

HP ProOne 400 G4 20-inch Non-Touch All-in-One Business PC User Manual Page 33