Hp Insight Control User Manual download pdf (Page 50)

• Turn off the hypervisor using the following command:

bcdedit /set hypervisorlaunchtype off

After the migration, you can re-enable the hypervisor using the following command:

bcdedit /set hypervisorlaunchtype auto

• Remove the Microsoft Hyper-V role from the source server.

Destination preparation

Destination server identification fails

The destination server identification fails in step 3 of the Wizard.

Suggested action

1. Verify that the network adapter on the destination server is configured with a valid IP address,

subnet, and gateway.

2. Verify that the destination server is booted from the Insight Control server migration Boot CD

ISO and ready for migration.

3. Verify that the destination server can be reached from the application station and source

server. Communication on network ports 51125 and 51126 must be enabled by any firewall

between the CMS, the source server, and the destination server.

4. Verify that another Insight Control application is not already communicating with the destination

server.

IP address configuration fails on a manually booted virtual machine in Microsoft

Hyper-V for a P2V or a V2V migration

You have manually created the virtual machine on Microsoft Hyper-V for a P2V or a V2V migration

and booted the virtual machine manually with the Insight Control server migration Virtual Machine

Boot CD ISO, however, you are unable to configure an IP address on the virtual machine.

Suggested action

Perform the following:

• Ensure that the virtual machine that you have manually created has a legacy network adapter.

• Ensure that the legacy network adapter on the virtual machine is connected to the correct

virtual network switch on the host.

• Ensure that the Virtual network switch configuration on the Microsoft Hyper-V host is correct

and the virtual switch is connected to a physical network adapter with external network

connectivity.

Kernel panic occurs when booting a virtual machine to the Insight Control server

migration Virtual Machine Boot CD ISO

Insight Control server migration requires that the destination virtual machine has at least 600 MB

of RAM to boot to the Insight Control server migration Virtual Machine Boot CD ISO.

Suggested action

To resolve this issue:

1. Power down the virtual machine.

2. Ensure that the virtual machine has at least 600 MB of RAM.

3. Reboot to the Insight Control server migration Virtual Machine Boot CD ISO.

50 Troubleshooting

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 77 78

No comments

Hp Insight Control User Manual Page 50