Hp Brocade 8Gb SAN Switch for HP BladeSystem c-Class User Manual download pdf (Page 34)

The gateway address of the first switch should be set to whatever the gateway address is for the

subnet on which the first switch resides. See Table 12.

Table 12 Connecting with a management station

Third switchSecond switchFirst switchManagement station

204.1.1.12204.1.1.11192.168.1.10192.168.1.09Ethernet

192.168.65.12192.168.65.11192.168.65.10192.168.65.09FCIP

192.168.1.10192.168.1.10any, not self192.168.1.10Gateway

Maintaining the 8Gb SAN Switch

The 8Gb SAN Switch does not require any regular physical maintenance.

However, it is critical that environmental conditions, described in Environmental requirements, page 53,

are met to help prevent switch failure due to heat stress or improper air flow.

Installing dust covers in empty ports

The dust covers included in the 8Gb SAN Switch shipping carton (see Figure 1) must be inserted in

ports where SFPs are not installed. Installing dust covers ensures proper air flow and helps reduce

dust contamination of the switch.

Replacing an SFP transceiver

In some cases, you might need to reinstall an SFP transceiver.

To remove an SFP transceiver:

1. Press and hold the cable release.

2. Remove the cable from the transceiver.

3. Pull the bail (wire handle) to release the transceiver.

4. Grasp the bail, and gently but firmly pull the transceiver out of the port.

5. Repeat this procedure for the remaining ports as required.

To install a replacement SFP:

1. Make sure that the bail is in the unlocked position.

Managing the 8Gb SAN Switch34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

No comments

Hp Brocade 8Gb SAN Switch for HP BladeSystem c-Class User Manual Page 34