Hp Brocade 8Gb SAN Switch for HP BladeSystem c-Class User Manual download pdf (Page 24)

NOTE:

Refer to the

HP BladeSystem Onboard Administrator user guide

for additional information on EBIPA.

Using external DHCP

To set the Ethernet IP address using external DHCP:

1. Connect to the active OA with a web browser.

2. Document the DHCP-assigned address by selecting the switch from the OA GUI Rack Overview

window.

3. Verify the IP address using a Telnet or SSH login to the switch, or select the switch in the OA GUI

Rack Overview window.

Setting the IP address manually

To set the IP address manually:

NOTE:

As an alternate method to using a null modem cable, use Telnet or SSH to access the IP address of

the Onboard Administrator, resuming at step 9 below.

1. Obtain the following items to set the IP address with a serial connection:

• Computer with a terminal application (such as HyperTerminal in a Windows environment or

TERM in a UNIX environment)

• Null modem serial cable

2. Replace the default IP address (if present) and related information with the information provided

by your network administrator. By default, the IP address is set to 10.77.77.77 for switches with

revision levels earlier than 0C.

3. Verify that the enclosure is powered on.

4. Identify the active OA in the BladeSystem.

5. Connect a null modem serial cable from your computer to the serial port of the active OA.

6. Configure the terminal application as follows:

In a Windows environment, enter:

• Bits per second—9600

• Databits—8

• Parity—None

• Stop bits—1

• Flow control—None

In a UNIX environment, enter: tip /dev/ttyb –9600

7. Log in to the OA.

8. Press Enter to display the switch console.

Setup24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

No comments

Hp Brocade 8Gb SAN Switch for HP BladeSystem c-Class User Manual Page 24