Hp 8.20q Fibre Channel Switch User Manual download pdf (Page 13)

HP StorageWorks Simple SAN Connection Manager user guide 13

2 Installing and removing Simple SAN Connection

Manager

This chapter provides procedures for installing Simple SAN Connection Manager on a Windows

management station, and for installing the required software components on other servers. It also provides

procedures for removing Simple SAN Connection Manager from a Windows system, as well as removing

the software components from Linux servers.

Installing Simple SAN Connection Manager

Use the HP StorageWorks Simple SAN Connection Manager CD to install the management software on

your management station as described in Windows installation, page 13. Then use the same CD to install

the HBA driver and other required software on each of the other servers in your SAN. Depending on the

server operating system for the non-management station installations, refer to either the steps for Windows

installation on page 13 or Linux installation on page 20.

Windows installation

Follow these steps to install the Simple SAN Connection Manager software on your management station,

or to install the required non-management software on all other servers running Windows.

To install Simple SAN Connection Manager on Windows:

1. Insert the installation CD into your computer’s CD-ROM drive.

The HP Installation Wizard starts automatically. (If the installer does not start automatically, run

Setup.exe from the installation CD.)

The initial installation window (Figure 2) opens.

Figure 2 Installation wizard: initial window

2. Click Next.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 97 98

No comments

Hp 8.20q Fibre Channel Switch User Manual Page 13