HP PROCURVE 8212ZL User Manual download pdf (Page 193)

182

Software Fixes in Release K.11.12 - K.13.49

Release K.13.03

■ CLI (PR_1000455370) — Commands that display portmaps may yield corrupted

output. For example, a single port may be displayed as a port range.

■ RIP (PR_1000751858) — Some static routes may not be correctly distributed by RIPv1 or

RIPv2.

■ PIM (PR_1000714322) — A new multicast stream may not get forwarded by the switch.

■ Crash (PR_1000759046) — Using the "\" character with or without other character

combinations may cause the switch to crash with a message similar to the following. There

may also be different crash messages resulting from the same problem.

Software exception at parser.c:2653 — in 'mSess1', task ID =

0x898e6a0-> ASSERT: failed

■ PIM (PR_1000749627) — A switch with PIM-SM may send a prune to the RP when none

is required.

■ Web Management (PR_1000472572) — The Web Management Interface does not

properly allow configuration of port monitoring/mirroring.

Addendum to Release K.13.02:

■ ACL (PR_1000714376/1000760152) — Attempts to apply an access group to a range of

ports will fail after the initial configuration unless a write mem and reload are done in

between configuration statements.

Release K.13.03

The following problems were resolved in release K.13.03.

■ Enhancement (PR_1000400991) — The 802.1X Controlled Directions feature now

functions independently of the STP configuration. For more information, see “Release

K.13.03 Enhancements” on page 75.

■ IPv6 (PR_1000768670) — When virus throttling is configured on a port that belongs to an

IPv6 enabled VLAN, some IPv6 all nodes (ff02::1) multicast traffic may be dropped.

■ Mirroring (PR_1000768655) — After a mirror ACL has been modified, some ACL

commands that follow may result in an unresponsive CLI session.

■ IDM ACL (PR_1000768727) — An IDM ACL that uses the syntax, destination ip "any"

will result in a parsing error, the ACL will not be applied, and the client authentication will

fail. Workaround: Instead of the term "any," use “0.0.0.0/0.”

■ VRRP PDT (PR_1000756475) — If the VRRP preemptive delay timer (PDT) is configured,

the virtual router mode (Owner or Backup) cannot be changed unless the PDT configuration

is removed.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 218 219

No comments

HP PROCURVE 8212ZL User Manual Page 193