HP ProLiant ML110 User's Guide download pdf (Page 52)

Hardware options installation 52

Enabling the Trusted Platform Module (on page 54).

Enabling the TPM requires accessing the ROM-Based Setup Utility (RBSU) ("HP ROM-Based Setup

Utility" on page 63). For more information about RBSU, see the HP website

(http://www.hp.com/support/smartstart/documentation).

TPM installation requires the use of drive encryption technology, such as the Microsoft® Windows®

BitLocker™ Drive Encryption feature. For more information on BitLocker™, see the Microsoft website

(http://www.microsoft.com).

CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines

can cause hardware damage or halt data access.

When installing or replacing a TPM, observe the following guidelines:

• Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system

board.

• When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption

technology. For security reasons, only the customer can enable these features.

• When returning a system board for service replacement, do not remove the TPM from the system board.

When requested, HP Service provides a TPM with the spare system board.

• Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM security

rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators should consider the

system compromised and take appropriate measures to ensure the integrity of the system data.

• When using BitLocker™, always retain the recovery key/password. The recovery key/password is

required to enter Recovery Mode after BitLocker™ detects a possible compromise of system integrity.

• HP is not liable for blocked data access caused by improper TPM use. For operating instructions, see the

encryption technology feature documentation provided by the operating system.

Installing the Trusted Platform Module board

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,

remove the power cord to remove power from the server. The front panel Power On/Standby

button does not completely shut off system power. Portions of the power supply and some internal

circuitry remain active until AC power is removed.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

1. Power down the server (on page 19).

2. Place the server on a flat, level work surface.

3. Remove the bezel ("Removing the front bezel" on page 19).

4. Remove the access panel ("Removing the access panel" on page 20).

5. Remove the system fan.

CAUTION: Any attempt to remove an

installed TPM from the system board breaks or disfigures

the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,

administrators should consider the system compromised and take appropriate measures to ensure

the integrity of the system data.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 113 114

No comments

HP ProLiant ML110 User's Guide Page 52