ξ Remove the electronicsΔenclosure
cover ξ page 6Δ5.
ξ Remove the window ξ page 6Δ15.
ξ
Remove the center cover ξ page 6Δ16.
ξ Remove the left endcover ξ page 6Δ18.
ξ Lift the left front trim clear of the
plotter.
ξ Remove the right endcover ξ page 6Δ19.
ξ Remove the frontΔpanel
assembly ξ page 6Δ32.
ξ Remove the carriage motor ξ page 6Δ35.
ξ Remove the media motor ξ page 6Δ37.
ξξ Remove the encoder strip ξ page 6Δ39.
ξξ Remove the bail ξ page 6Δ56.
ξξ Remove the service station ξ page 6Δ57.
ξξ
Remove the overdrive
roller ξ page 6Δ60.
In the following step, take care
not to damage the bail sensor.
CAUTION
ξξ Remove the three screws that attach the
mediaΔmotor mount to the right sideplate.
ξξξξξξξξξξξξ
ξ Press down on the media
mount as you replace the three screws.
This is to ensure correct spacing between
the drive roller and the cartridge nozzles.
(Details ξ chapter 9.)
ξξξξξ ξ
ξξξ ξξξξ ξξ
ξξξ ξξξξξξξ ξξξξξξ
ξξ
ξξξξξξξξξ ξξξξξ
Torx-20
ξξ Unclip the cables from the holding clip
underneath the mediaΔmotor mount.
ξξ Lift the mount clear of the plotter.
ξξ Remove the screw that attaches the
media director to the chassis assembly
and remove the media director.
Media director
Torx-15
ξξ Pull the pinchΔarm lever forward to raise
the pinchΔarm assembly.
Pinch-arm lever
6Δ69 Removal and ReplacementC3187Δ90000
ξξξξξξξξ ξξξ ξξξξξ ξξξξξξ
Comments to this Manuals