Hp 220 User Manual download pdf (Page 131)

The order in which you replace the screws on the entry platen is important.

 If the plotter is attached to a support, detach it.

 Turn the plotter on its back.

 Reconnect the media sensor to the entry platen (see also page 6Ć26).

 Position the entry platen between the two sideplates.

 Replace the indicated screw on the

leftĆhand side. ( dogĆpoint screw.)

Tighten this screw, making sure that the

entry platen is aligned tight against the

 sideplate.

Torx-15

 Replace the indicated screw on the

rightĆhand side. ( dogĆpoint screw.)

There must be no space between the entry

platen and the  sideplate. It doesn't

matter if there is a small space between

the entry platen and the  sideplate.

Torx-15

 

 

Position the top of the entry platen under all of the small pivots on the inside

of both sideplates, except the back pivot. Rest the entry platen against the back pivot.

Position the bottom of the entry platen above the bottom cover of the plotter.

6Ć67 Removal and ReplacementC3187Ć90000

   

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 245 246

No comments

Hp 220 User Manual Page 131