HP PCL 5 User Manual Page 152

  • Download
  • Add to my manuals
  • Print
  • Page
    / 286
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 151
6-32 Raster Graphics EN
For Method 3—since delta row compression requires that the
seed row be available whenever raster graphics mode is
entered, the seed row is initialized to zeros upon raster
graphics mode entry (
?*r#A). The seed row is also initialized
upon receipt and completion of each raster block.
For Method 3—if the row length terminates the data before the
control byte value is satisfied (literal byte count greater than
row length), the data following the control byte, if any, is printed
as text. The cursor is incremented.
For Method 3—if the row length is equal to one, the current
row is duplicated and the cursor is incremented.
Transfer Raster Data Commands
There are two Transfer Raster Data commands: Transfer Raster Data
by Plane and Transfer Raster Data by Row.
Transfer Raster Data by Plane—This command (
?*b#V) is
used when the raster data is encoded by plane as specified by
the Simple Color command (
?*r#U) or the Configure Image
Data command (
?*v#W). The Transfer Raster Data by Plane
command is used to send each plane in the row except the
last; the Transfer Raster Data by Row command (
?*b#W)
must be used to send the last plane and advance the cursor to
the beginning of the next row.
Transfer Raster Data by Row—This command (
?*b#W)
moves the current active cursor position to the next pixel row
after its execution. It is used for monochrome printers for the
last plane in a multi-plane row, or for color raster transfer when
the data is encoded by pixel.
Both commands are described in detail in the following paragraphs.
Chapter 2 provides additional descriptions and examples using the
Transfer Raster Data commands to print color images.
Page view 151
1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 285 286

Comments to this Manuals

No comments