HP StorageWorks Disk System 2100 (fld rck 0 drvs) User Manual download pdf (Page 10)

HP StorageWorks Disk System 2100 / 211010

SCSI ID Switch

The SCSI ID switch sets the address for the disk drives.

There are three possible settings for the SCSI address switch: A, B, and C. Each

setting assigns a different set of addresses to the disk modules installed in the disk

system. For SCSI address switch setting A, the addresses for the installed disk

modules are (from left to right, looking at the disk system from the front) 0, 2, 4, and

6. For SCSI address switch setting B, the addresses for the installed disk modules are

8, 10, 12, and 14. For SCSI address switch setting C, the addresses for the installed

disk modules are 9, 11, 13, and 15. See Figure 5, below.

SCSI address 7 is reserved for use by the host bus adapter.

FIGURE 5

SCSI ID Switch Settings

Note The disk system requires a terminator when it is installed at the end

of the SCSI bus.

SCSI

Address

Switch

Setting

Disk Module SCSI Addresses (Viewed from front of storage enclosure)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

No comments

HP StorageWorks Disk System 2100 (fld rck 0 drvs) User Manual Page 10