HP LP 1000r User's Guide download pdf (Page 15)

2 Opening and Closing the HP

Netserver

Introduction

This chapter describes how to the remove the top cover, front bezel, and the air

duct from the HP Netserver LP 1000r.

WARNING Before removing the top cover, always disconnect the power

cord and unplug telephone cables. Disconnect the power cord

to avoid exposure to high energy levels that may cause burns

when parts are short-circuited by metal objects, such as tools

or jewelry. Disconnect telephone cables to avoid exposure to

shock hazard from telephone ringing voltages.

Tools Required

The following tool may be needed to remove the air duct for the first time:

• ¼-inch flat blade screwdriver (for the air duct)

Removing the Front Bezel

The front bezel is provided to protect the power and reset switches from

accidental disabling.

To remove the front bezel, follow these steps:

NOTE You do not need to removal the front bezel to remove the top

cover of the Netserver. You do need to remove the front bezel

to install mass storage devices or media.

1. If the Netserver is operating, you do not need to turn off power to remove

the front bezel.

2. Release the front bezel by placing your hand at the center of the half-moon

opening in center of the front bezel. See Figure 2-1.

3. Pull out towards you on the front bezel.

The bezel rotates down to approximately an 80

° angle.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 139 140

No comments

HP LP 1000r User's Guide Page 15