HP LP 1000r User's Guide download pdf (Page 123)

Chapter 13 Alternative Rack Mounting (4–Post)

117

Release

Spring

Assembly

3/4 CCW

1/4 CW

Figure 13-2. Releasing Spring Assembly

Marking the Columns

Use this section to mark the front and rear columns of the HP Systems rack. The

outer-rails mount to the face of the front columns and the inside face of the rear

columns. The masking tape (or marking pen) is used to identify and mark the

locations on the columns.

CAUTION If other rack components are to be mounted in the rack below

the HP Netserver, install those components before starting to

mount the Netserver.

NOTE Use the HP Rack Configuration Tools to determine where in

the rack to mount the HP Netserver.

1. Find the EIA unit markings on the rack and the location for the Netserver.

The screw holes cover a span of only one EIA unit, which is the height

requirement of the HP Netserver.

NOTE The Netserver can only be mounted into both holes of one EIA

Unit, but cannot be mounted across two EIA units. You cannot

use a hole in one EIA unit and a hole in another EIA unit.

2. Use the masking tape (or marking pen) to mark above the 3rd hole up on

both front columns, as shown in Figure 13-3.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 139 140

No comments

HP LP 1000r User's Guide Page 123