HP DL120 - ProLiant - G5 User's Guide download pdf (Page 29)

Using LO100 29

To modify Chassis Actions, select a Power Control Option in the Chassis Actions section, and then click

Apply.

To identify the server in the rack and illuminate the UID (the LED on the front panel of the server), from the

UID list, select the length of time for the UID to illuminate, and then click Identify.

NOTE: The UID is not available on all LO100 servers. For more information, see your server

user guide.

A restore policy controls how the system responds when power is connected to the server. To set a restore

policy:

1. Select the Power Restore Policy by choosing one of the following options:

o Always power up—Powers on the server immediately after power is supplied.

o Restore to powered state prior to power loss—Powers on the system if the system was in the

powered on state before a loss of power.

o Power pushbutton or command required to power on system—Causes the server to wait for

external action before powering on the system.

2. Click Set.

Controlling server power through the CLP

1. Log in to LO100 CLP as described in the "Logging in to LO100 (on page 26)" section.

2. Change to the system1 target by entering cd system1.

3. To power on the server, enter start /system1. For example:

/./system1/> start /system1

System1 started.

4. To power off the server, enter stop /system1. For example:

/./system1/> stop /system1

System1 stopped.

The -force option can also be used with the stop command. This option forces the

implementation to stop the target, ignoring any policy that might cause the implementation to

normally not execute the command. In remote management processor implementation, this process is

equivalent to a hard power down.

5. To reset the server, enter reset /system1. For example:

/./system1/> reset

System1 reset.

Monitoring sensors

LO100 provides operating system-independent remote monitoring of the current status of major sensors of

a target server including system temperature, fans, and voltage. You can view the data for this feature on

the Monitoring Sensors Page through a web browser or through the BIOS Setup Utility.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 68 69

No comments

HP DL120 - ProLiant - G5 User's Guide Page 29