HP 8800 Router Series Installation Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 121
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Installing a DC power supply
1. Remove the air filter frame of the power supply and gently pull the DC power supply handle out.
2. Holding the handle of the power supply with one hand and supporting the bottom of the power
supply with the other hand, push the power supply slowly along the slide rails until it makes
close contact with the backplane, as shown in Figure 10.
3. Fasten the mounting screws on the power supply panel with a Phillips screwdriver.
4. Cover the power supply with the removed air filter frame.
Figure 10 Installing a DC power supply
Installing an AC power supply
Installing a NEPS3500-A AC power frame
For a router that requires power supply redundancy, install the same number of power supplies in the
two power frames.
1. Push the power frame slowly along the slide rails until it makes close contact with the backplane.
2. Fasten the mounting screws on the power frame panel with a Phillips screwdriver.
Figure 11 Installing a NEPS3500-A power frame
13
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 120 121

Comments to this Manuals

No comments