HP rx1620 User Manual download pdf (Page 60)

Figure 56 Power Supply Removal/Replacement

4. Carefully lift the power supply cable free from all retaining clips.

5. At the rear of the chassis, remove the two screws holding the power receptacle to the chassis.

6. Lift the power supply forward and away from the chassis to remove. The power receptacle

and cord are integral components of the power supply.

Replacing the Power Supply

To replace the power supply, perform the following steps:

1. Perform the power supply removal procedure described above.

2. Place the replacement power supply into the chassis slot at the front of the power distribution

unit.

3. Slide the power supply toward the rear of the chassis, engaging the power supply connector

with the connector on the power distribution unit.

4. Connect the power receptacle of the replacement power supply to the rear panel of the chassis.

5. Carefully route the power supply cord from the rear of the chassis at the receptacle to the front

of the chassis through the access slot near the power supply fan unit.

60 Removing and Replacing Components

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 72 73

No comments

HP rx1620 User Manual Page 60