HP rx1620 User Manual download pdf (Page 39)

10. Lift the processor up and out of the chassis. Place the processor into an antistatic container.

Figure 35 Removing the Processor

Replacing a Processor

Processors are located on the system board. The system board can support either one or two

processors. CPU 0 is located to the right of the system board, and CPU 1 (when installed) is located

on the left of the system board next to the bridge assembly. In a single CPU configuration, the

single processor must be installed in CPU 0 slot.

Each processor has an associated power pod that is required by the processor.

CAUTION: Do not modify the settings of the DIP switches located on the system board. These

switches are for factory use. Failure to observe this caution will result in system failure.

Removing and Replacing a Processor 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 72 73

No comments

HP rx1620 User Manual Page 39