HP 002-01A User's Guide download pdf (Page 10)

6 Upgrading and Servicing Guide

c On the outside of the door, do the following:

a Slowly pull out the square-cornered edge of the inlay (C, near the rear of the

chassis) to free the three snaps along the left side of the inlay.

b Continue to slowly pull out the edge of the inlay to free the two columns of

three snaps located on each side of the middle of the inlay.

c Holding the inlay near to the door, slide it toward the back of the chassis to

free it.

d Set the inlay aside.

To install the inlay, see “Replacing the access door” on page 8.

CAUTION: To avoid damaging the inlay, do not pull out the inlay more than

2.54 cm (1 inch) away from the door.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

No comments

HP 002-01A User's Guide Page 10