HP IO Accelerator for BladeSystem c-Class Windows User Manual download pdf (Page 42)

Utilities 42

If the IO Accelerator device is in minimal mode, then auto-attach is disabled until the cause of the device

being in minimal mode is fixed.

Syntax

fio-attach <device> [options]

where <device> is the name given to the IO Accelerator during the installation process. The syntax is

/dev/fctx, where x indicates the PCIe bus number where you installed the IO Accelerator. For example,

the name /dev/fct4 refers to the IO Accelerator device installed in PCIe Bus 4 in your Windows®

operating system. Use the IO Accelerator Management Tool or fio-status to view this bus number.

You can specify multiple IO Accelerator devices. For example, /dev/fct /dev/fct2 indicates the IO

Accelerator devices installed in PCIe Buses 1 and 2 in your Windows® operating system.

Options

Option Description

-c

Attach only if clean.

-q

Quiet: disables the display of the progress bar and percentage.

fio-beacon

Description

The fio-beacon utility turns on all three LEDs of the specified IO Accelerator for identification. You must

detach the IO Accelerator device and then run fio-beacon.

This utility is not applicable for the mezzanine format of the IO Accelerator, which has no externally visible

LEDs.

Syntax

fio-beacon <device> [options]

where <device> is the name given to the IO Accelerator during the installation process. The syntax is

/dev/fctx, where x indicates the device number.

Options

Option Description

-0

Off: Turns off the three LEDs

-1

On (default): Lights the three LEDs

-p

Prints the PCI bus ID of the device at <device> to standard output. Usage and error information

might be written to standard output rather than to standard error.

fio-bugreport

Description

Prepares a detailed report of the device for use in troubleshooting issues.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

No comments

HP IO Accelerator for BladeSystem c-Class Windows User Manual Page 42