HP 9040 User's Guide download pdf (Page 176)

setting. For example, for the HP LaserJet 9040/9050mfp, trays 1 and 4 are listed in both the Form to

Tray Assignment setting and the Installable Options setting.

The input trays listed here are also listed as media sources on the Page Setup tab.

Font Substitution Table

Clicking this option opens the font substitution table and makes available the options for changing

the TrueType-to-PostScript font mapping.

PostScript Configurations

The following controls are available and appear in the PS Emulation Driver.

Available PostScript Memory

This control specifies the amount of available postscript memory and provides a spin box for

changing this value. The available postscript memory is a subset of the product total physical

memory. It is usually best to set the postscript memory to match what is shown on the configuration

page. To print a configuration page from the control panel, press the Select button (the one with the

check mark) to open the menus. Next, press the up and down buttons to scroll to INFORMATION,

and then press the

SELECT

button. Next, press the up and down buttons to scroll to PRINT

CONFIGURATION, and then press the

SELECT

button.

Output Protocol

This control specifies the protocol that the product uses for print jobs. The following options are

available:

■ ASCII (default)

■ TBCP

■ Binary

When you click ASCII, data is sent in ASCII format (7-bit), which might take longer to print but can be

sent through any I/O channel, such as a serial, parallel, or network port.

When you click TBCP (Tagged Binary Communications Protocol), all data except special control

characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial

communications ports and are faster than sending data in ASCII format.

When you click Binary, all data except special control characters is sent in binary (8-bit) format. The

binary formats can be sent over parallel or serial communications ports and are faster than sending

data in ASCII format.

Send Ctrl-D Before Each Job

This control specifies whether the product will be reset at the beginning of every postscript

document. The default setting is No. Ctrl-D resets the product to its default setting to ensure that

previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail if the

product is connected through a network. If your document fails to print when sent to a product

connected through parallel or serial ports, change No to Yes.

160 3 HP traditional print drivers for Windows

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 329 330

No comments

HP 9040 User's Guide Page 176