HP 9800 Series User Manual download pdf (Page 22)

You may need to adjust the wide/narrow knobs depending on

the width of your supply. See "Adjusting the Wide/Narrow

Knobs" for more information.

If the printer will be unused for extended periods of time, we

recommend leaving the printhead unlatched.

Loading Labels for the Optional Peel Mode:

Peel mode is an option that must be purchased separately. In

peel mode, the printer separates the backing paper from the

label. The next label is not printed until the completed one is

removed from the printer. Make sure the printer is configured for

on-demand mode and the correct supply type.

The minimum feed length is 1.5 inches for peel mode. We

recommend using 0.5-inch gap supplies in peel mode when

backfeed is disabled. Hold the leading edge of peeled labels

when printing on stock longer than six inches. You must use

non-perforated supplies for peel mode. Follow the steps for

loading supplies from the previous section. Then, follow these

steps after you close the printhead.

1. Remove the labels from the first 10 inches of the backing

paper.

2. Press down on the exit cover tabs to open the exit cover on

the front of the printer.

Exit Cover

2-6 Loading Supplies

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

No comments

HP 9800 Series User Manual Page 22