HP Compaq 8100 Elite Series User's Guide download pdf (Page 27)

Installing and Removing Drives

When installing additional drives, follow these guidelines:

●

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA

connector on the system board.

●

Connect a SATA optical drive to the white SATA connector on the system board.

●

Connect an optional eSATA adapter cable to the black ESATA connector on the system board.

●

Connect a media card reader USB cable to the media USB connector on the system board. If the

media card reader has a 1394 port, connect the 1394 cable to the 1394 PCI card.

●

The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.

●

You must install guide screws to ensure the drive will line up correctly in the drive cage and lock

in place. HP has provided extra guide screws for the external drive bays (five 6-32 standard screws

and four M3 metric screws), installed in the front of the chassis, under the front bezel. The 6-32

standard screws are required for a secondary hard drive. All other drives (except the primary hard

drive) use M3 metric screws. The HP-supplied metric screws are black and the HP-supplied

standard screws are silver. If you are replacing the primary hard drive, you must remove the four

silver and blue 6-32 isolation mounting guide screws from the old hard drive and install them in the

new hard drive.

NOTE: Your computer may look different than the illustration shown below.

Figure 18 Extra Guide Screw Locations

No. Guide Screw Device

1 Black M3 Metric Screws All Drives (except hard drives)

2 Silver 6-32 Standard Screws Secondary Hard Drive

There are at total of five extra silver 6-32 standard screws. Four are used as guide screws for a secondary

hard drive. The fifth is used for bezel security (see

Front Bezel Security on page 47 for more information).

ENWW Installing and Removing Drives 21

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

No comments

HP Compaq 8100 Elite Series User's Guide Page 27