HP DesignJet 815MFP User Manual download pdf (Page 65)

hp designjet 815mfp & scanner 4200 59

see also

maintenance procedures on page 24

tell me about the scanner insertion slot

You can change the insertion slot height from 2 to 16 mm (0.08 to

0.63 inches). The Normal position (Step 0: 2 mm/0.08 in) is

detected by a sensor in the scanner.

The insertion slot is marked with a measurement ruler for inches and

millimeters. The ruler corresponds to right side aligned original

loading. Just below the ruler are marked common standard sizes

that help guide you with optional centered loading.

The loading method, right-side or centered, can be selected from

your scanner software. The scan area width measured in standard

units (inches or millimeters) is also set from the software.

The required setting for an original drawing can be measured with

the original inserted into the scanner by using the ruler printed on

top of the insertion slot. Then, you just enter your measurement in

the width setting box in the current scanner application’s media size

setup dialogs. To change the insertion slot height, see how do I

change the insertion slot height? on page 8.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 109 110

No comments

HP DesignJet 815MFP User Manual Page 65