HP DesignJet 815MFP User Manual Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
56 hp designjet 815mfp & scanner 4200
If the Diagnostic and the Wait lights continue to flash after cleaning
and restarting, then there may be camera position errors that
require professional service.
wait light
The Wait light comes on when the scanner power is turned
on, and stays on during the internal diagnostic and stabilization
phase.
The Wait light reveals the status of the scanners self-adjustment
procedure, which consists of both stitching and light profile
adjustment. If the scanner does not self adjust the stitching and light
profiles may change over time due to thermal changes in the
scanner. The Wait light works in the following way:
When the Wait light is off, the self-adjustment is up-to-date,
and the scanner is ready to scan.
When the Wait light is on, the scanner is warming up or re-
adjusting; a scan may be issued, but quality may be
compromised (when adjusting is completed, the Wait light
turns off). To allow the scanner to self-adjust, do not remove the
original or change Original Pressure Platen position while the
Wait light is on.
When the Wait light is flashing (and the Diagnostics light is
off) re-adjusting is needed, but not possible; any original in the
scanner should be removed, and Original Pressure Platen
should be returned to the normal position (also in this situation
a scan may be issued, but the quality will be compromised).
When adjusting is again possible, the Wait light stops
flashing, but continues to be on until the self-adjust is complete.
The Wait light is on during basic calibration to indicate that
the original should not be removed during this procedure The
scanner keyboard is disabled during basic calibration for the
same reason.
paper control area
paper forward and paper reverse keys
Use the Paper Control area when you insert your
document.
The Paper Forward Key moves the drawing into the start-of-scan
position. If the auto-load option is selected in your software, loading
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 109 110

Comments to this Manuals

No comments