Hp ProLiant DL560 Gen8 Server User Manual download pdf (Page 55)

Hardware options installation 55

To install the optional FlexibleLOM:

1. Firmly seat the FlexibleLOM in the slot, and then tighten the thumbscrew.

2. Install the PCIe riser cage ("Install the primary PCIe riser cage" on page 22).

3. Install the access panel (on page 20).

4. Slide the server into the rack.

5. Connect the LAN segment cables.

6. Connect each power cord to the server.

7. Connect each power cord to the power source.

8. Power up the server (on page 18).

Expansion board options

The server supports PCI Express expansion boards. The server ships with PCIe riser boards and expansion

slots. PCIe expansion boards are supported with optional riser boards.

Removing the expansion slot blanks

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,

remove the power cord to remove power from the server. The front panel Power On/Standby

button does not completely shut off system power. Portions of the power supply and some internal

circuitry remain active until AC power is removed.

CAUTION: For proper cooling, do not operate the server without the access panel, baffles,

expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize

the amount of time the access panel is open.

To remove the component:

1. Power down the server (on page 18).

2. Remove all power:

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 101 102

No comments

Hp ProLiant DL560 Gen8 Server User Manual Page 55