Hp ProLiant DL560 Gen8 Server User Manual download pdf (Page 11)

Component identification 11

Slot PCIe 3-slot riser cage* PCIe 2-slot x16 riser cage

6 - HL/FH

PCIe2 or PCIe3** x8 (8,4,2,1) —

*Depending on the server model, the server might ship with one or two riser cages installed.

**These slots can run 8 GT/s signaling rate in either PCIe2 or PCIe3 mode, depending on the capability of the installed

processor.

†PCIe slot 3 is connected to the southbridge and runs at the Gen2 signaling rate.

Notes:

"Primary" denotes the riser cage is installed in the primary riser connector.

"Secondary" denotes the riser cage is installed in the secondary riser connector.

Installing the riser cages listed in the table above in either the primary or secondary riser connectors determines the form

factor of the PCIe cards supported by those riser cages.

FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.

The PCIe 2-slot x16 riser cage supports a maximum power of 150 W with an HP power cable. This cable must be used

for PCIe card wattages greater than 75 W.

System board components

Item Description

Processor 3 DIMM slots (7-12)

Front power switch

Processor 3 socket

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 101 102

No comments

Hp ProLiant DL560 Gen8 Server User Manual Page 11