HP EliteDesk 800 G3 Tower PC User Manual download pdf (Page 25)

11. To install a half-length expansion card, hold the card just above the expansion socket on the system

board then move the card toward the rear of the chassis (1) so that the bottom of the bracket on the

card slides into the small slot on the chassis. Press the card straight down into the expansion socket on

the system board (2).

NOTE: When installing an expansion card, press rmly on the card so that the whole connector is

seated properly in the expansion card socket.

12. To install a full-length expansion card you must remove the hard drive cage to allow room for installing

the card.

a. Disconnect the power and data cables from the rear of the drives in the hard drive cage.

b. Push the green drivelock mechanism on the hard drive cage away from the hard drive bays (1), lift

the rear of the drive cage up (2), and then slide the drive cage back and lift it out of the chassis (3).

Removing or installing an expansion card 19

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 64 65

No comments

HP EliteDesk 800 G3 Tower PC User Manual Page 25