HP EliteDesk 700 G1 Microtower PC User Manual download pdf (Page 32)

●

Secure the drive to the bay adapter bracket by installing four black M3 adapter bracket

screws through the sides of the bracket into the drive.

7. Install four mounting screws into the sides of the drive (two on each side).

NOTE: The lower hard drive bay requires silver and blue mounting screws. The upper hard

drive bay requires all silver mounting screws. HP has supplied four extra silver mounting screws

installed on the chassis next to the hard drives that are used when installing a hard drive in the

upper drive bay. Refer to

Installing and removing drives on page 19 for an illustration of the

location of the extra mounting screws. When replacing a hard drive in the lower bay, use the four

silver and blue mounting screws that were removed from the old drive to install the new drive.

●

If installing a hard drive in the upper (secondary) drive bay, use the extra silver mounting

screws that can be retrieved from the chassis next to the hard drive bays.

26 Chapter 2 Hardware upgrades

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

No comments

HP EliteDesk 700 G1 Microtower PC User Manual Page 32