Hp D3000 Disk Enclosures User Manual download pdf (Page 29)

Installing disk drives in the enclosure

Disk drive options

Depending on the enclosure model, 12 or 25 disk drives can be installed in the enclosure.

A variety of disk drive models are supported for use, including dual-ported and single-ported

models. For more information about supported disk drives, see the QuickSpecs for the disk enclosure,

available on the D3000 website.

Disk drive guidelines

CAUTION:

• Follow industry-standard practices when handling disk drives. Internal storage media can be

damaged when drives are shaken, dropped, or roughly placed on a work surface.

• When installing a disk drive, press firmly to make sure the drive is fully seated in the drive

bay and then close the latch handle.

• When removing a disk drive, press the release button and pull the drive only slightly out of

the enclosure. Then, to allow time for the internal disk to stop rotating, wait approximately 10

seconds before completely removing the drive from the enclosure.

• Always populate hard drive bays starting with the lowest bay number. If only one hard drive

is used, install it in the bay with the lowest device number.

• Disk drives are hot-pluggable.

• SAS and SATA disk drives may be installed in the same enclosure, but can not be included

in the same RAID logical volume.

Installing a disk drive

CAUTION: To prevent improper cooling and thermal damage, operate the enclosure only when

all bays are populated with either a component or a blank.

1. Remove the drive blank.

2. Unlatch and swing out the latch handle on the drive. Then, slide the drive into the bay (1),

pressing firmly on the drive to seat it. Close the latch handle (2), pressing firmly until it locks

in place.

Installing disk drives in the enclosure 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 68 69

No comments

Hp D3000 Disk Enclosures User Manual Page 29