HP SN6000 User's Guide download pdf (Page 87)

Fabric OS Command Reference 59

53-1003108-01

auditCfg

Modifies and displays the audit log filter configuration.

SYNOPSIS auditcfg --class audit_class

auditcfg --enable | --disable

auditcfg --severity severity_level

auditcfg --show

DESCRIPTION Use this command to configure the audit logging and to display the audit log configuration. This

command allows you to set filters by configuring certain classes, to add or remove any of the classes in

the filter list, to set severity levels for audit messages, and to enable or disable audit filters. Based on the

configuration, certain classes are logged to syslog for auditing. Syslog configuration is required for

logging audit messages. Use the syslogdIpAdd command to add the syslogd server IP address.

NOTES The RAS class is not configurable; its function is to audit the audit log management operations and it is

always enabled internally.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in

place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for

details.

OPERANDS This command has the following operands:

--class

Configures filters for a specified audit class. To add or remove any of the classes

in the filter list, reissue the --class option.

audit_class

Specifies the filters to be configured. Valid values are: 1-ZONE, 2-SECURITY,

3-CONFIGURATION, 4-FIRMWARE, 5-FABRIC, 6-FW (Fabric Watch), and 7-LS

(Logical Switch), 8-CLI, 9-MAPS. The filter is specified by its numeric value. To

add more than one filter, the numeric values must be separated by commas.

Spaces are not permitted. This operand is required.

--severity

Sets audit severity level to a specified value. When severity is set, only log

messages of type severity_level and higher are displayed. You cannot enter

multiple severity levels.

severity_level

Valid values are INFO, WARNING, ERROR, and CRITICAL. By default, all

messages are logged. This operand is required.

--enable

Enables all filters. This action enables an existing configuration; it does not

change the configuration.

--disable

Disables all filters.This action disables an existing configuration; it does not

change the configuration.

--show

Displays the current configuration. This operand is optional.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 121 122

Comments to this Manuals

No comments

HP SN6000 User's Guide Page 87

Comments to this Manuals

Related products and manuals for Software HP SN6000