Hp Designjet 4520 Printer series User Manual download pdf (Page 37)

12. Wind the excess paper onto the roll. Use the paper stop to turn the roll in the direction shown.

13. Lower the window.

14. The front panel again prompts you to wind excess paper onto the roll.

15. The printer will perform a color calibration, if it has not already calibrated the paper type you are

using, and if color calibration is turned on. See

Perform color calibration on page 68.

16. The front panel displays the Ready message and the printer is ready to print.

Unload a roll from the printer [4020]

NOTE: This topic applies to the HP Designjet 4020 Printer series only.

Before unloading a roll, check whether the end of the roll is still attached to the spindle, and follow the

appropriate procedure as described below.

The normal procedure (roll attached to spindle)

If the end of the roll is still attached to the spindle, use the following procedure.

1. At the printer's front panel, select the

icon, then Paper unload > Unload roll.

2. The paper will normally be removed from the printer.

If the paper is not automatically removed from the printer, the front panel will prompt you to lift the

paper load lever and turn the paper stop (1) by hand until the paper is removed from the printer.

When you have finished, lower the paper load lever.

3. Turn the paper stop (1) by hand, until the paper is fully wound onto the roll.

4. Press the Select key.

ENWW Unload a roll from the printer [4020] 27

Paper

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 234 235

No comments

Hp Designjet 4520 Printer series User Manual Page 37