HP Integrity rx2600 Specifications Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Mechanical design and packaging of the HP Integrity rx1600 server
The exploded view reveals the location of major components as well as the mechanical and architectural features
of the Integrity rx1600 server. It is partitioned into three electrical partitions—the system board, including CPUs,
memory, and core I/O; the I/O backplane, including four PCI-X I/O slots; and the management processor board.
Figure 2. Major components of the HP Integrity rx1600 server
Enhanced system
mgmt card
8 DIMM slots
512 MB to 16 GB
with chip sparing
zx1 Chipset
Deerfield CPUs
Front
p
anel
2 PCI-X slots
(133 MHz)
400W power
supply
Slimline CD/DVD-R or
CD-RW/DVD–R
(
o
p
tional
)
2 hot-swap Ultra320
drives
(internal RAID support
w/optional RAID card)
Two hot-swap disk drive bays are located in the lower right corner of the server (when viewed from the front). Just
above the power supplies is a slimline optical media drive bay, supporting either a DVD or a DVD/CD-RW
combo drive. Directly behind the power supplies and peripheral bays are four cooling fans.
The left side of the system houses the I/O backplane and I/O card bay. There are two PCI-X slots in the I/O
card bay; one full-length slot and one half-length slot.
The right rear of the server contains the main system board. The system board contains two Intel Low Voltage
Itanium 2 processor sockets, 8 memory DIMM slots, and the core I/O controllers. The management processor sits
on an independent circuit board that attaches to the rear of the main system board.
Racking density
The Integrity rx1600 server is designed to provide unprecedented performance density. At only one EIA unit
(EIA unit = 1.75 inches) per server, up to 41 systems can be installed into a single 2-meter HP cabinet.
The Integrity rx1600 server is supported in HP Rack System/E and 10000 series racks. The server is also
supported in a variety of third-party, non-HP racks and cabinets.
Note: Dimensions for rack configuration are as follows: height = 1.7 inches (4.3 cm), depth = 26.8 inches (68.0
cm), width = 19 inches (48.2 cm).
6
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Comments to this Manuals

No comments