HP SCSI Host Bus Adapters Installation Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
Hardware and Software Installation Procedure
Step 9: Verify the SCSI installation
8
1000Base-T Adapter
/dev/mpt8
ext_bus 9 1/0/4/0/1 mpt CLAIMED INTERFACE HP AB290A PCI-X 2port U320
SCSI/2port 1000Base-T Adapter
/dev/mpt9
In this example, two AB290A adapters are installed on the system. The fourth and fifth
columns in the ioscan output indicate that the adapters have been claimed by the mpt
driver. The third column shows the hardware path of the slot in which the card is
installed. This path will be different for each installed card. The AB290A adapter
supports two PCI devices or functions (one per channel). Two lines are listed for each
AB290A adapter, —one for channel A (denoted by a 0 as the last digit in the hardware
path), and one for channel B (denoted by a 1 as the last digit in the hardware path). The
device file for each channel of each installed adapter is in the second line of the ioscan
output, for example: /dev/mpt6 or /dev/mpt7.
For more detailed information on installed AB290A adapter(s), including the SCSI
parameter settings as well as verification of devices that have been connected to the
AB290A adapter(s), issue the mptconfig <dev file> command for each channel of
each AB290A adapter. Use the device files displayed in the ioscan -fnkd mpt output.
For example:
# mptconfig /dev/mpt8
Scan For Devices ...
---- ADAPTER INFORMATION -----------------------------------------------------
Device File : /dev/mpt8
Hardware Path : 1/0/4/0/0
---- BUS PARAMETERS ----------------------------------------------------------
Initiator SCSI ID : 5
SCSI Bus Rate : Ultra320
SCSI Bus Width : Wide
---- CHANNEL CAPABILITIES ----------------------------------------------------
Req/Ack Offset : 127
Bus Mode : LVD
Quick Arbitration Selection : Enabled
DT Clocking : Enabled
Packetized : Enabled
---- TARGET PARAMETERS -------------------------------------------------------
Target Description Firmware In Use In Use
Id Version Rate Width
------------------------------------------------------------------------------
0 ST318453LC HPC3 Ultra320 Wide
2 ST373453LC HPC3 Ultra320 Wide
4 ST373453LC HPC4 Ultra320 Wide
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Comments to this Manuals

No comments