HP Officejet 7310 All-in-One Printer User Manual download pdf (Page 17)

To reset to factory defaults

1 On the control panel of the HP all-in-one, press the Setup button.

2 Press 8, and then press 2.

This displays the Network menu and then selects Restore Network Defaults.

3 Press 1 to confirm.

Advanced network settings

The Advanced Setup options enable you to change link speed, IP settings, and

memory card security.

Note Unless you are an advanced user, you should not change any of these settings.

Set link speed

You can change the speed at which data is transmitted over the network. The default is

Automatic.

To set the link speed

1 On the control panel of the HP all-in-one, press the Setup button.

2 Press 8, and then press 3.

This displays the Network menu and then selects Advanced Setup.

3 Press 1 to select Change Link Speed.

4 Press the number next to the link speed:

– 1. Automatic

– 2. 10-Full

– 3. 10-Half

– 4. 100-Full

– 5. 100-Half

Change IP settings

The default IP setting is Automatic. However, if necessary, you can manually change

the IP address, subnet mask, or the default gateway. To see the IP address and subnet

mask of your HP all-in-one, print a network configuration page from your HP all-in-one

(see Print and view a network configuration page). For a description of the items on the

configuration page, including the IP address and subnet mask, see Configuration page

definitions.

To change an IP setting

1 On the control panel of the HP all-in-one, press the Setup button.

2 Press 8, and then press 3.

This displays the Network menu and then selects Advanced Setup.

3 Press 2 to select IP Settings.

4 Press the number next to the IP setting:

– 1. IP Address

– 2. Subnet Mask

– 3. Default Gateway

5 Enter your changes, and then press OK when done.

Chapter 5

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

No comments

HP Officejet 7310 All-in-One Printer User Manual Page 17