HP 11i User Manual download pdf (Page 43)

Chapter 4 43

Protocol Specific Configuration

Terminal-Definition

mux:port:subc The port assigned must be configured as above and the ACC

card must have the appropriate HDLC/LAP-D firmware

configured. You must also have defined the subchannel number

in the Subchannel definition section.

dtype The device type of the HDLC/LAP-D terminal must be

LAPD.DLE.

poll/select This supplies the “POLL” and “SELECT” parameters

for the ZCOM Terminal-Definition. These are used to

specify:

• whether the HDLC/LAP-D terminal acts as a DTE

(user side) or DCE (network side),

• the frame re-transmission time-out value,

• the re-transmission count limit,

• the outstanding f rame window size to be used, a nd

• the maximum f rame size allowed.

In most cases a pre-configured keyword will suffice. For

the list of currently predefined keywords, see

“Predefined Configuration Values” section of this

chapter. If a different set of values is required, then

different values for the “POLL” and “SELECT” codes

may be entered here in the standard poll and select

format in hexadecimal. For the format of these words,

see “Poll/Select/Option Configuration Values” on page

46.

appl_no Application number (Application dependent - has no effect on

protocol).

inst_no Institution number (Application dependent - has no effect on

protocol).

brch_no Branch number (Application dependent - has no effect on

protocol).

wkst_no Workstation number (Application dependent - has no effect on

protocol).

area_no Area number (Application dependent - has no effect on

protocol).

Thefiveparametersabovearefortheuseofthe

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

No comments

HP 11i User Manual Page 43