HP 34970A User Manual download pdf (Page 205)

100

101

The MEASure? and CONFigure Commands

Both the MEASure? and CONFigure commands reset all measurement

parameters to their default values. For more information on the default

settings for these commands, see the table on page 201.

• For the range parameter, MIN selects the lowest range for the

selected function; MAX selects the highest range; AUTO or DEF

selects autoranging. For more information on autoranging, refer to

“General Measurement Configuration” starting on page 98.

• For the resolution parameter, specify the resolution in the same units

as the measurement function, not in number of digits. MIN selects

the smallest value accepted, which gives the highest resolution;

MAX selects the largest value accepted, which gives the least resolution;

DEF selects the default resolution which is 0.000003 x range (1

PLC).

For more information on resolution, see the table on page 203.

MEASure? Command Syntax

MEASure:TEMPerature?

TCouple,{B|E|J|K|N|R|S|T|DEF}

[,1[,<

resolution>|MIN|MAX|DEF}]] ,(@<scan_list>)

Configure the specified channels for thermocouple measurements and

immediately sweep through the scan list one time. Note that this command

also redefines the scan list. The readings are sent directly to the

instrument’s output buffer but the readings are not stored in reading

memory. The default (DEF) transducer type is a J-Type thermocouple.

Chapter 5 Remote Interface Reference

The MEASure? and CONFigure Commands

207

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 428 429

Comments to this Manuals

No comments

HP 34970A User Manual Page 205

Comments to this Manuals

Related products and manuals for Multimeters HP 34970A