HP Z600 Specifications Page 115

  • Download
  • Add to my manuals
  • Print
  • Page
    / 238
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 114
Removing a hard disk drive from the hard drive bay
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Press the green hard disk drive release tab
, lift the handle
2
, and then use the handle to pull
the hard disk drive from the chassis as shown in the following figure.
Figure 5-36 Removing the drive from the chassis
4. Carefully separate the upper hard disk drive carrier rails, and then tilt the drive outward
2
as
shown in the following figure.
Figure 5-37 Removing the drive from the carrier
Carefully separate the lower carrier rails , and then remove the drive from the carrier.
5. Reinstall all removed components and reconnect all cables that have been disconnected.
ENWW Removing and installing components 103
Page view 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 237 238

Comments to this Manuals

No comments