HP 4500 DN User Manual Page 130

  • Download
  • Add to my manuals
  • Print
  • Page
    / 220
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 129
130 Printer Control Panel Messages
EN
49 ERROR (XXXX)
CYCLE POWER
A critical software error has
occurred.
Turn the printer off and then on
to clear the error. If this does
not solve the problem try the
following:
1) Cancel the current print job
from your PC or server.
Resend the print job. If this
does not work, try sending a
different job.
2) If your computer is
connected to the printer
through a parallel cable, verify
that the cable is connected
correctly and is of good quality.
3) If the problem persists, call
service.
50.X FUSER ERROR A fusing error has occurred.
X indicates the error type as follows:
X
Description
1 Low fuser temperature
2 Fuser warm up service
3 High fuser temperature
4 Faulty fuser
5 Fuser voltage mismatch
6 Fuser heater cutoff
7 Fuser motor malfunction
Clear the error by turning the
printer off and then on. If the
problem persists, call service.
For 50.5 Fuser Errors (Fuser
voltage mismatch), verify that
the fuser is the same voltage
type as the printer.
51 LASER ERROR A laser error has occurred due to a
beam detect error or laser failure.
Clear the error by turning the
printer off and then on. If the
problem persists, call service.
52 SCANNER ERROR A scanner failure has occurred. Clear the error by turning the
printer off and then on. If the
problem persists, call service.
Printer Control Panel Messages (continued)
Message Description Recommended Action
Page view 129
1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 219 220

Comments to this Manuals

No comments