Hp ProCurve 802.11g Access Point Card 170wl Series User Manual Page 1

HP ProCurve Wireless 170wl Radio Card External Antenna User’s Guide

8Using an External Antenna with the 170wl Radio CardInstallation ProcedureTX Power Control LimitsNote TX Power Control is only supported on the HP Pr

9Using an External Antenna with the 170wl Radio CardInstallation Procedure5. Click the Configure button located on the left side of the screen. 6. Cl

10Using an External Antenna with the 170wl Radio CardInstallation Procedure7. Select Operational Mode. Note In Operational Mode, it does not matter h

11Using an External Antenna with the 170wl Radio CardInstallation Procedure11. Reboot the Access Point for the changes to take effect. Configuring TX

Technical information in this document is subject to change without notice.Copyright Hewlett-Packard Company, 2004. All rights reserved. Reproduction

Hewlett-Packard Company8000 Foothills Boulevard, m/s 5552Roseville, California 95747-5552http://www.hp.com/go/hpprocurve© Copyright 2004 Hewlett-Pack

1Using an External Antenna with the 170wl Radio CardHP provides a variety of external antenna options for extending the radio range and shaping the c

2Using an External Antenna with the 170wl Radio CardExternal Antenna OptionsExternal Antenna OptionsThe 170wl radio card external antenna options are

3Using an External Antenna with the 170wl Radio CardPre-Installation ConsiderationsPre-Installation ConsiderationsPlanning the InstallationTo determi

4Using an External Antenna with the 170wl Radio CardPre-Installation Considerations• For optimum coverage, mount the antenna at the center of the are

5Using an External Antenna with the 170wl Radio CardInstallation ProcedureInstallation Procedure1. Mount the AntennaInstall the antenna in its planne

6Using an External Antenna with the 170wl Radio CardInstallation Procedure4. Remove the rubber tab from the end of the radio card. 5. Connect the ada

7Using an External Antenna with the 170wl Radio CardInstallation Procedure3. Configure the Radio Transmit Power Control LevelsThe access point must b