Hp 620 User Manual download pdf (Page 21)

2-9

Installing and Connecting the ProCurve 620 Redundant and External Power Supply

Installation Procedures

Installing and Connecting the ProCurve

620 Redundant and External Power Supply

4. Connect to AC Power

Connect the AC power cord supplied with the 620 RPS/EPS to the power

connector on the back of the unit, and then into a properly grounded electrical

outlet.

Figure 2-3. Connecting AC power

The 620 RPS/EPS does not have a power switch. They are powered on when

the power cord is connected to the unit and to a power source. For safety, the

power outlet should be located near the unit installation.

The 620 RPS/EPS automatically adjusts to any voltage between 100-127 or

200-240 volts and either 50 or 60 Hz. There are no voltage range settings

required.

If your installation requires a different power cord than the one supplied with

the unit, be sure the cord is adequately sized for the unit’s current require-

ments. In addition, be sure to use a power cord displaying the mark of the

safety agency that defines the regulations for power cords in your country.

The mark is your assurance that the power cord can be used safely with the

unit.

Connect the AC power cord to

the power connector

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

No comments

Hp 620 User Manual Page 21