Hp 33s User Manual download pdf (Page 146)

11–2 Statistical Operations

Entering One–Variable Data

1. Press

{

} to clear existing statistical data.

2. Key in each x–value and press



3. The display shows n, the number of statistical data values now accumulated.

Pressing



actually enters two variables into the statistics registers because the

value already in the Y–register is accumulated as the y–value. For this reason, the

calculator will perform linear regression and show you values based on

y even

when you have entered only

x–data — or even if you have entered an unequal

number of

x–and y–values. No error occurs, but the results are obviously not

meaningful.

To recall a value to the display

immediately after it has been entered, press

{



Entering Two–Variable Data

In RPN mode, when your data consist of two variables, x is the independent

variable

and y is the dependent variable. Remember to enter an (x, y) pair in

reverse order (y



x)so that y ends up in the Y–register and X in the

X–register.

1. Press

{

} to clear existing statistical data.

2. Key in the y–value first and press



3. Key in the corresponding x–value and press



4. The display shows n, the number of statistical data pairs you have

accumulated.

5. Continue entering x, y–pairs. n is updated with each entry.

To recall an

x–value to the display immediately after it has been entered, press

{

Correcting Errors in Data Entry

If you make a mistake when entering statistical data, delete the incorrect data and

add the correct data. Even if only one value of an x, y–pair is incorrect, you must

delete and reenter

both values.

To correct statistical data:



1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 386 387

Comments to this Manuals

No comments

Hp 33s User Manual Page 146

Comments to this Manuals

Related products and manuals for Calculators, organizers Hp 33s