HP ProOne 400 G2 Base Model 20-inch Touch All-in-One PC User Manual download pdf (Page 29)

Removing and installing memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-

SDRAM) small outline dual inline memory modules (SODIMMs).

SODIMMs

The memory sockets on the system board can be populated with up to two industry-standard

SODIMMs. These memory sockets are populated with at least one preinstalled SODIMM. To achieve

the maximum memory support, you can populate the system board with up to 16 GB of memory.

DDR3-SDRAM SODIMMs

For proper system operation, the SODIMMs must be:

●

industry-standard 204-pin

● unbuffered non-ECC PC3-10600 DDR3-1600 MHz-compliant

● 1.5 volt DDR3-SDRAM SODIMMs

The DDR3-SDRAM SODIMMs must also:

●

support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)

●

contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification

In addition, the computer supports:

● 1-Gbit, 2-Gbit, and 4-Gbit non-ECC memory technologies

● single-sided and double-sided SODIMMS

●

SODIMMs constructed with x8 and x16 SDRAMs; SODIMMs constructed with x4 SDRAMs are

not supported

NOTE: The system will not operate properly if you install unsupported SODIMM memory.

HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid

compatibility issues with unsupported third-party memory.

Removing and installing memory 23

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 58 59

No comments

HP ProOne 400 G2 Base Model 20-inch Touch All-in-One PC User Manual Page 29