HP ProDesk 600 G2 Small Form Factor PC User Manual download pdf (Page 50)

Front bezel security

The front bezel can be locked in place by installing a security screw provided by HP. To install the security

screw:

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB flash drives, from the computer.

3. Turn off the computer properly through the operating system, then turn off any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as

the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to

the internal components of the computer.

5. If the computer is on a stand, remove the computer from the stand.

6. Remove the computer access panel.

7. If you do not have a 6-32 standard screw, remove one of the four silver 6-32 standard screws located

on top of the drive cage. Refer to

Installing and removing drives on page 21 for an illustration of the

6-32 standard screw locations.

8. Install the 6-32 security screw through the middle front bezel release tab to secure the front bezel in

place.

9. Replace the computer access panel.

10. If the computer was on a stand, replace the stand.

11. Reconnect the power cord and any external devices, and then turn on the computer.

12. Lock any security devices that were disengaged when the access panel was removed.

44 Chapter 2 Hardware upgrades

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56 57 58

No comments

HP ProDesk 600 G2 Small Form Factor PC User Manual Page 50