HP Ink Tank Wireless 412 User Manual download pdf (Page 3)

Important Ink Information

After you have set up the printer, do not open the printhead latch unless you are installing new printheads or

moving the printer outside your home or oice. In addition, you should maintain proper ink levels in the ink tanks

when printing.

Maintain proper ink levels

Use the ink level lines on the ink tanks to determine when to ll the tanks and how much ink should be added.

Never print when any of the ink tanks has less than the minimum amount of ink. Printing with too little ink or lling

tanks with too much ink can damage the printer and aect print quality. Make sure you match the color of the ink to

the color on the ink tank when you rell an ink tank. See the Start here booklet for instructions on how to ll the ink

tanks.



Minimum ink level

Ink level should never go below the minimum ink line.

Printing with ink level below the minimum line may cause

damage to your printer.



Maximum ink level

Do not ll ink above the maximum ink line. Overlling

might cause ink leakage. When you rell, some ink might

be left in the ink bottle. You can save the remaining ink by

storing the ink bottle in a dry cool place for future relling.

NOTE: Product service or repairs required as a result of lling the ink tanks improperly and/or using non-HP ink will

not be covered under warranty.

Display Error Solution

Printhead Carriage Stall

1. Open the front door, and then open the printhead access door.

2. Make sure the printhead latch is properly closed and the print carriage is not

obstructed.

IMPORTANT: Do not open the printhead latch but check that it is pushed down

rmly. Keep printhead latch closed unless installing new printheads or moving

printer outside your home or oice.

3. Close printhead access door, then front door.

4. Press

(the Resume button) to continue printing.

Paper Jam

Clear the jam, and then press

(the Resume button) to continue printing.

For more information, see the user guide on www.support.hp.com.

System Maintenance

Required

Open the printhead access door completely, and then close it immediately.

This process helps remove ink buildup and maintains the best print quality

throughout the life of the printer.

IMPORTANT: Do not open the printhead latch unless you get this message, or

are installing new printheads, or moving the printer outside your home or oice.

Out of Paper

The Error icon (

), the Paper

Error icon ( ), and Resume

light ( ) are blinking.

1. Load paper in the input tray.

2. Press

(the Resume button) to continue printing.

NOTE: For more information on how to load paper, see the user guide on

www.support.hp.com.

Printhead Problem

The Error icon (

), one or both

Printhead icons ( ), and

Printhead Alert light

( ) are blinking.

Flashing left printhead icon: Indicates an error with the tri-color printhead.

Flashing right printhead icon: Indicates an error with the black printhead.

If you are setting up the printer for the rst time, make sure you have removed

the tape from the printhead.

If you have been using your printer and are starting to see print quality

problems, the printhead indicated needs to be replaced. Contact HP support at

www.support.hp.com to get a replacement printhead.

Moving printer after setup

To prevent damage to the printer or ink leakage, follow these instructions.

If you are moving the printer within your home or oice, keep the printhead latch closed, and keep the printer level.

If you are moving the printer outside your home or oice, visit www.support.hp.com or contact HP.

English

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

HP Ink Tank Wireless 412 User Manual Page 3

Comments to this Manuals

Related products and manuals for Unknown HP Ink Tank Wireless 412