HP Switch TA688-96138 User Manual download pdf (Page 27)

6 Using the VMware VSA laptop demo

The VMware VSA laptop demo is the smallest and most portable version of the LeftHand OS

software virtual appliance. Use this demo to create HP StoreVirtual Storage, complete with storage

clusters.

NOTE: There is not a separate demo version of the HP StoreVirtual VSA for Microsoft Hyper-V

Server.

The VSA can be used for free indefinitely as a single system iSCSI target with snapshots. If a

configuration is deleted and recreated, the trial period of licensed features starts again.

To use the VSA fully featured on an ESX Server, purchase a license and follow the instructions in

“Installing the HP StoreVirtual VSA for VMware vSphere” (page 6) to set up virtual HP StoreVirtual

Storage.

The VSA runs a full-featured version of the LeftHand OS software, and provides the following

capabilities:

• Use of the LeftHand OS software without requiring physical storage devices.

• Use of advanced LeftHand OS software features such as Clustering and Virtualization, Managed

Snapshots, Remote Copy and Multi-Site SAN during an evaluation period.

The demo is available at www.hp.com/go/tryvsa.

Requirements for the demo

• The demo VSA is supported on 64–bit systems only

• Minimum of 3 GB of RAM

• One virtual CPU with 2GHz reserved

• A dedicated gigabit virtual switch

• 5 GB to 2 TB of disk space per virtual disk, up to 10 TB total per virtual storage appliance

• VMware Player, Workstation, or Server

• IP address, subnet mask, and gateway for the virtual machine

Planning the demo installation

Before you install the VSA, plan the virtual network configuration. Then, when you install the CMC,

plan and configure the hardware features before configuring the virtual storage system for data

storage.

• Virtual appliance directories, host names and IP addresses. Create a directory for each virtual

machine on the hard drive you will use as the storage system.

• Network configuration. Plan the subnet and IP address for the virtual machines as well as for

the VIPs required for storage clusters.

• Storage configuration. Install the CMC on a Linux or Microsoft Windows OS. Then use the

CMC to find storage systems, create storage, and connect to application servers.

Installing the VSA

When you start the VSA for the first time with a VMware console, you will:

• Unzip to the prepared directory and start the virtual machine.

• Direct the Ethernet port to NAT (default), Host-only, or bridged.

• Set the IP address and host name of the VSA.

Requirements for the demo 27

1 2 ... 22 23 24 25 26 27 28 29 30 31

No comments

HP Switch TA688-96138 User Manual Page 27