Hp MPX200 Multifunction Router User Manual download pdf (Page 128)

Step 3. Rack-mount the MPX200

See “MPX200 components” (page 26).

Step 4. Install the SFPs

To install the SFPs:

NOTE: An SFP transceiver is required for each FC port that connects to an FC switch.

1. Align the SFP transceiver so that the key is oriented correctly to the port. Transceivers are

keyed so that they can be inserted only one way.

2. Insert the transceiver into the port.

3. Press gently until the transceiver snaps into place.

Step 5. Set the MPX200 management port parameters

Use the following steps to set initial MPX200 configuration parameters or, if already configured,

go to step 6.

NOTE: If you are using Telnet to configure the MPX200 for the first time, your workstation IP

address must be "10.0.0.x," where x is a number other than 1 and the subnet mask is 255.0.0.0.

1. Connect the MPX200 management port or serial console port to a workstation to set the initial

MPX200 configuration parameters. You can connect the MPX200 management port to an IP

switch, a hub, or directly to the workstation using an Ethernet crossover cable. If you are using

the MPX200 serial port, the settings are 115,200 baud, 8 bit, 1 stop bit, no parity, and no

flow control.

2. Attach both AC power cords to the PCM located at the front of the MPX200, and a power

distribution unit or AC power outlet. Verify that the MPX200 system power LED is lit. The

MPX200 runs a self-test and enters operating mode.

3. Verify that the heartbeat LED is blinking (once per second) and that the System fault LED does

not light. “MPX200 chassis diagnostic LEDs” (page 141) shows the location of the ports and

LEDs on the MPX200.

NOTE: For a description of the LED fault indicators, see the “MPX200 chassis diagnostics”

(page 141).

4. Connect to the MPX200 from your management workstation as follows (Figure 108 (page

129)).

a. Enter guest at the Login prompt.

b. Enter password at the Password prompt.

NOTE: HP recommends that you change the MPX200 guest password after logging in.

5. Enter Blade n at the mpx200#> prompt, where n is the number of the blade in the chassis

being configured.

6. Enter admin start at the mpx200 <n> prompt, where n is the number of the blade currently

selected in the chassis.

7. Enter the default password config.

NOTE: HP recommends that you change the MPX200 config password after logging in.

128 MPX200 FCIP

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 257 258

No comments

Hp MPX200 Multifunction Router User Manual Page 128