HP 4000M User Manual download pdf (Page 119)

6-43

Configuring the Switch

Spanning Tree Protocol (STP)

Configuring the Switch

STP Fast Mode

For standard STP operation, when a network connection is established on a

device that is running STP, the port used for the connection goes through a

sequence of states (Listening and Learning) before getting to its final state

(Forwarding or Blocking, as determined by the STP negotiation). This

sequence takes two times the forward delay value configured for the switch.

The default is 15 seconds on HP switches, per the IEEE 802.1D standard

recommendation, resulting in a total STP negotiation time of 30 seconds. Each

switch port goes through this start-up sequence whenever the network con-

nection is established on the port. This includes, for example, when the switch

or connected device is powered up, or the network cable is connected.

A problem can arise from this long STP start-up sequence because some end

nodes are configured to automatically try to access a network server when-

ever the end node detects a network connection. Typical server access

includes to Novell servers, DHCP servers, and X terminal servers. If the server

access is attempted during the time that the switch port is negotiating its STP

state, the server access will fail. To provide support for this end node behavior,

the Switches 1600M/2424M/4000M/8000M offer a configuration mode, called

“Fast Mode”, that causes the switch port to skip the standard STP start-up

sequence and put the port directly into the “Forwarding” state, thus allowing

the server access request to be forwarded when the end node needs it.

If you encounter end nodes that repeatedly indicate server access failure when

attempting to bring up their network connection, and you have enabled STP

on the switch, try changing the configuration of the switch ports associated

with those end nodes to STP Fast Mode.

Caution The Fast Mode configuration should be used only on switch ports connected

to end nodes. Changing the Mode to Fast on ports connected to hubs, switches,

or routers may cause loops in your network that STP may not be able to

immediately detect, in all cases. This will cause temporary loops in your

network. After the fast start-up sequence, though, the switch ports operate

according to the STP standard, and will adjust their state to eliminate continu-

ing network loops.

To Configure Fast Mode for a Switch Port. From the switch console

configuration screen for Spanning Tree Operation, shown on page 6-41:

1. Select the [Edit] action.

2. Scroll or Tab to the Mode column for the port you want to change.

3. Press the Space Bar to display Fast.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 303 304

No comments

HP 4000M User Manual Page 119