HP 10TB User's Guide download pdf (Page 90)

5. Push down on the SAS I/O module lever (2, Figure 56 (page 90)), and then remove the failed

SAS I/O module (3, Figure 56 (page 90)).

NOTE: You may need to use significant force to accomplish this task.

Figure 56 Removing the SAS I/O module

Replacing the SAS I/O module

1. To install the replacement SAS I/O module (Figure 57 (page 90)):

a. Insert the SAS I/O module into the enclosure (1).

b. Push up on the SAS I/O module lever (2) until it locks into place.

NOTE: You may need to use significant force to accomplish this task.

Figure 57 Replacing the SAS I/O module

2. Plug in all cables to the SAS I/O module.

IMPORTANT: You must install the SAS I/O cables in the same slots from which they were

removed or the system might fail.

3. Verify that the replacement SAS I/O module is working properly by checking the overall

module status LED (“SAS I/O module LEDs status” (page 44)).

NOTE: The green overall module status LED should turn on within five seconds after the new

module is inserted in the system, which reflects the necessary time to boot the firmware.

90 Removing and replacing hardware components

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 180 181

No comments

HP 10TB User's Guide Page 90