Hp Spectre x2 User Manual download pdf (Page 35)

2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.

Reverse this procedure to install the solid-state drive.

WWAN module

Description Spare part number

HP lt4114 LTE 4G Module 761233-005

HP lt4110 LTE/HSPA+ 4G Module 756993-005

CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module

authorized for use in the slate by the governmental agency that regulates wireless devices in your country or

region. If you replace the module and then receive a warning message, remove the module to restore device

functionality, and then contact technical support.

Before removing the WWAN module, follow these steps:

1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then

shut it down through the operating system.

2. Disconnect the power from the slate by unplugging the power cord from the slate.

3. Disconnect all external devices from the slate.

4. Remove the display panel assembly (see Display panel assembly on page 20).

Remove the WWAN module:

1. Disconnect the WWAN antenna cables (1) from the terminals on the WWAN module.

NOTE: The WWAN antenna cable labeled “5/MAIN” connects to the WWAN module “Main” terminal.

The WWAN antenna cable labeled “6/AUX” connects to the WWAN module “Aux” terminal.

2. Remove the Phillips PM2.0×2.5 screw (2) that secures the WWAN module to the slate. (The WWAN

module tilts up.)

Component replacement procedures 25

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 70 71

No comments

Hp Spectre x2 User Manual Page 35